X-Line FIR_Drive v2.1 Preset Notes
4-12-11 MDK

The preset options in this folder are the X-Line FIR_Drive v2.0 (standard EV flat preset) and the X-Line FIR_Drive v2.0M (Musical preset). 
You may choose which preset best suits your tastes. (NOTE: Do not mix the standard preset with the musical preset.)

Subwoofers are time-aligned and level-adjusted to be flown in the same array, or in an array directly next to the main hang. 
The subwoofer level is set for a 1/1 ratio of subwoofers to top boxes. Subwoofer output level and alignment delay may need to be adjusted for your application.

The Xvls and Xvlt presets are time-aligned to allow multi-pattern array creation. 

These presets were created for use with the TG-series amplifiers equipped with RCM-26 DSP cards. 
IRIS v2.4 with RCM Firmware 1.15 is required for use with these settings. These presets can also be used in the Dx46 processor with FIR Drive. 
These presets can be used with an N8000 (NetMax) using IRIS-Net v2.5.  Contact the EV Technical Support Group if you have questions regarding FIR_Drive and the N8000.

The X-Line FIR_Drive v2.0 settings include the new EV TEMP (Thermal Energy Management and Protection) limiter. 
This limiter in combination with the EV PA (Peak Anticipation) Limiter provide supperior protection for your transducers and PA. 

No acoustic changes have been made from X-Line FIR v1.1 settings. TEMP limiter changes have been made from X-Line FIR_Drive v2.0.

If you have other questions or comments about the presets, please contact EV Technical Support at:

Pro Audio - Technical Support Group 
Bosch Communications Inc
12000 Portland Ave S 
Burnsville MN  55337-1522
USA

Phone: 800-392-3497 
FAX:   952-884-0043 
Web:   www.boschcommunications.com 
 